Product 2023
Recuperator (Turkey)
Recuperator // Straight Pipe
Save
01 / 01
Description
| GENERAL FEUTURES | |
|---|---|
| ■ A waste heat recovery device using furnace exhaust gas preheat combustion air which results energy savings. | ■ The recuperator transfers some of the waste heat in the exhaust to the compressed air, thus preheating it before entering the fuel burner stage. |
| ■ Has short amortisation period between 3-10 month, which depends on capacities, intented use and duration of running period. ■ Depending on the operating conditions and design could be made as Fin-tube or Plain-tube. |
■ Each 20°C reduction in the temperature of the of the flue inert hot gases provides savings of approximately 1%(These values become higher in the case of condensation of Gas fired boilers flue gases) ■ Could be made as 2 stage type: 1st. Stage high-temperature water heater 2nd. Stage heating the combustion air. |
| ADVANTEGES | |
|---|---|
| ■ Waste heat recovery and additional energy saving, | ■ Eco-friendly, |
| ■ Increase your production capacity and reduce energy bills, | ■ Each device has its own design according to customers needs and can easily fit at all types of working spaces, |
| ■ Heat loss is prevented by mesh wire rockwool insulation. | |
| DİSADVANTEGES | |
|---|---|
| ■ It creates counter pressure on the water and fule gas side. ■The flue gas temperature can fall below the condensing flue gas temperature. Correct design is required. |
■ May reduce burner and stack airflow. |
| TECNICAL FEUTURES | |
|---|---|
| Heat Capacities | 50.000-3.000.000kcal/h |
| Max.Operating Pressure | 3-30bar |
| Max.Temperature | 100-1.200°C |
| Type | Cylindrical-Horizontal |
| Fuel | |
| Design Code |
CE marked as per Pressure Equipment Directive |
| Design Standart | EN 12952/EN 12953 |
